DR110.4
                                   RECEIVER

1.  Disconnect the PINK wire connected to the MIC connector and the PC Board
    from the PC Board
2.  Reconnect the PINK wire to PIN 2 on the IF Board connector
         This eliminate the low pass filtering on the discriminator!

That is it to the MOD for the 110, 112, and the 1200!  Remember, you now use
the MIC Connector For inputting 9600 baud and it WILL work for 1200 baud!
A special note to all SYSOPS out there...Buy this radio and do this MOD!  It 
will allow users to set their TXDelay down to a lower setting giving the 
channel MORE throughput!  USERS, make a DONATION to your SYSOPS so they can
help make the system YOU are using, BETTER!  We must all do our part to help!
I would like to hear from all of you that tries this MOD!

I GIVE PARTIAL CREDIT TO BARRY, KA1BOY, FOR HIS INPUT ON THIS MODIFICATION!!!
73 FELLOW PACKETEERS!!!        DINO...KC6RIX @ WF6O.#SOCA.CA.USA.NA

I have made this mod, and I have the following suggestions:
(a) you can get a "map" of the board via FAX or snail mail from Alinco
    -- this helps a LOT (it's impossible to read component labels) --
    Alinco is in Torrance Calif, in the phone directory.
(b) Throw away C40, it is impossible for a mere mortal to do what they
    are suggesting.  Replace that SMT C40 with an axial .01uf cap
    (non-polarized, anything kind you want, I used a tant.) and some
    insulation tubing over the leads (it needs to stretch 2 inches
    across the bottom of the pcb.

Alinco claims this mod makes 1200bps unusable, untrue, I use my modded
1200 on both 1200 and 9600 bps without noticable degredation of
performance.

Regards,
Paul