FT736R.23 32/ Repeat the Magic Number of 9,2,4,9. 33/ Repeat Step 5. 34/ Repeat Step 6, Now slowly Tune Across the Two Band Edges, Until you see 00.000.0 MHz, 35/ Now Whilst still in the PMS Press the VFO A Button. 36/ Repeat the Magic Number of 9,2,4,9. 37/ Repeat Step 5. 38/ Repeat Step 6, Now Press either of the UP or DOWN scan Buttons, and you will find that the RIG will scan between 00.000.0 MHz to 999.999.9 MHz, or 999.999.9 MHz to 00.000.0 MHz. Now that you have set your RIG scanning UP and DOWN, you will find a number of signals on the Band, However you will hear signals up and down the Band that are not there, This can be checked out with a scanner, A signal Generator and a Digital Frequency Meter, But if you do not have these, Do not worry Because you do not need them, Simply put 138.000.0 MHz in to VFO A, And 156,999,9 MHz in to VFO B. 39/ Repeat the Magic Number of 9,2,4,9 in that Order. 40/ Repeat Step 5. 41/ Repeat Step 6. You Have completed this Modification, There are 3 more Mods for this Rig, with the Possiblity of a fourth for the American 220 MHz Band, But as yet I do not have any infomation on this Modification, Mod 2 is for 430/440 MHz, The OFFSET is 09.999.9. The Repeater Shift is + RPT. Press the REV KEY ( KEY 5 ) Followed by the UP MHZ BUTTON. Mod 3 is for 50 MHz, The OFFSET is 01.999.9. The Repeater Shift is + RPT. Press the REV KEY ( KEY 5 ) Followed by the UP MHZ BUTTON. Mod 4 IS for 1296 MHz, The OFFSET is 59.999.9. The Repeater Shift is + RPT. Press the REV KEY ( KEY 5 ) Followed by the UP MHZ BUTTON. Mod 5 is for 220 MHz, The OFFSET is 05.999.9. The Repeater Shift is + RPT. Press the REV KEY ( KEY 5 ) Followed by the UP MHz Button All These Mods are for Receiving only, and can not be used to Transmit out of Band. The End PAGE 4