TS830

here is an easy filter modification for the kenwood ts-830s. first to use 
this mod, your rig need the yk-88c and to mak  t even better, the yg-455c 
installed. in short what we are going to do, is move around a 9 volt 
switching voltage. this voltage comes from the af board, connector no. 7, 
pin no. 5. its marked rlr on the schematic. this voltage ends up at 
the pll assembly, connector no. 8, pin novp2. please do try this 
modification by cutting in this circuit at he source, because this 
same switching voltage feeds the if shiqo circuit, and the vbt circuit, 
and the pll. so cutting the wire at the af board will make the pll 
unlock when the mode switch is anywhere but in the cw positions. now 
to te prtceires.
1. remove the top and bottom covers, and turn the radio upside down with 
front facing you.

w2. locate the mode switch, and on the middle wafer set of contacts, 
cut the white wire with the blue stripe. it is located next to 
1the terminal with no conn ction, on the middle wafer set of contacts9)3-;3 
about 1/4 inch ox wire on t switch contact, so youcan make a connection 
there later.
CONTINUED IN FILE TS830.6